Using The Remote; Changing Button Assignments - Sony HT-DDW680 Operating Instructions Manual

Using the Remote

Changing button
assignments
You can change the factory settings of the
input buttons to suit the components in your
system. For example, if you connect a DVD
recorder to the DVD jacks on the receiver, you
can set the DVD button on this remote to
control the DVD recorder.
1
Hold down the input button of
which you want to change the
assignment.
Example: Press DVD.
2
Referring to the table below,
press the corresponding button
for the category you want.
Example: Press 4.
Now you can use the DVD button to
control the DVD recorder.
Categories and the
corresponding buttons
Categories
VCR (command mode VTR 3)
VCR (command mode VTR 2)
DVD player/DVD recorder
(command mode DVD1)
DVD recorder
(command mode DVD3)
CD player
MD deck
Tape deck B
Tuner (this receiver)
DVR (Digital CATV terminal)
DSS (Digital Satellite Receiver)
a)
Sony VCRs are operated with a VTR 2 or VTR 3
setting which correspond to 8 mm and VHS
respectively.
b)
Sony DVD recorders are operated with a DVD1 or
DVD3 setting. For details, refer to the operating
instructions supplied with the DVD recorders.
To clear all remote button
assignments
Press ?/1, AUTO CAL and MASTER VOL –
at the same time.
The remote is reset to its factory settings.
Press
a)
1
a)
2
3
b)
4
b)
5
6
7
8
9
0/10
49
GB