Advertisement
Memory Features
This telephone can store 10 telep h o n e
nu m b e rs , e a ch up to 16 digits long.
Numbers will remain stored in
memory unless you erase or change
them by entering other numbers.
Programming a Number
into Memory
Make sure the handset is
1 Press
. The PHONE indica-
tor will blink to indicate that you
are in the programming mode.
2 Enter a number button (0-9).
3 Enter the phone number
(up to 16 digits).
4 Press
to store the phone
number to the key you selected.
The phone now exits
and emits a tone.
NOTE: You may choose to store
emergency numbers in memory
locations. The manufacturer assumes
no responsibility for customer
reliance upon this memory featur e.
Dialing a Number Stored in Memory:
1 Press
to get a dial tone.
2 Press
.
3 P ress the number button (0-9) yo u
assigned to that phone nu m b e r.
For example, to dial the phone
number you assigned to button
"6", press
,
IN USE/CHARGE Indicator
When the handset is in the base
cradle, the IN USE/CHARGE
indicator increases intensity with
each ring of the incoming call. When
the handset is not in the base, the
IN USE/CHARGE indicator flashes
steadily. After the call is answered,
the IN USE/CHARGE indicator will
remain lit until the end of the call.
There is a memory card with an
erasable surface located on the
base to record names or telephone
numbers of the numbers stored in
memory locations.
Programming a Pause Into a Memory
When programming a number into
.
memory, store the access number and
a pause into the number sequence.
The pause will allow the switchboard
enough time to give you an outside
line dial tone.
mode
,
.
M E M O RY
Memory Card
Dial Phone Number
Memory Card
5
To insert a pause in a stored nu m b e r,
p ress and hold down the key that
comes befo re the pause, until you hear
a second beep. This inserts a 2-second
pause after that digit. To insert a
l o n ger pause, hold the key down until
you hear a third or fo u rth beep. Each
time you hear another beep , it make s
the pause 2 seconds longe r.
For example, to store 9, PAUSE,
555-1234: Press
and hold it
until you hear a second beep.
Then press
NOTE: Each pause you program
is counted as a digit. You can
program up to 16 digits in each
memory location.
Changing or Replacing a
Stored Number
You can change or replace a stored
number by storing a new number in
its place.
Spare Battery Charger
(under Memory Card)
Base Antenna
POWER indicator
goes on when the
base power adapter
is plugged into an
electrical outlet.
IN USE/CHARGE
indicator—see
description above.
SPARE BATTERY
indicator goes on
when you are
charging a
spare battery.
Page/Handset
Locator
.
Advertisement
