Fitting the trimmer guard and trimmer
head
•
Fit the correct trimmer guard (A) for use with the
trimmer head.
C
A
•
Hook the trimmer guard/combination guard onto the
fitting on the shaft and secure with the bolt (L).
•
Fit the drive disc (B) on the output shaft.
H
C
A
•
Turn the output shaft until one of the holes in the drive
disc aligns with the corresponding hole in the gear
housing.
•
Insert the locking pin (C) in the hole to lock the shaft.
•
Screw on the trimmer head/plastic blades (H)
anticlockwise.
14 – English
ASSEMBLY
L
A
B
B
•
To dismantle, follow the instructions in the reverse
order.
Fitting the blade guard and saw
blade
H
•
Remove the mounting plate (H). Fit the adapter (I) and
bracket (J) with the two screws (K) as shown. Fit the
blade guard (A) to the adapter using the 4 screws (L)
as shown.
CAUTION! Always use the recommended guard for
the cutting attachment you are using. See chapter on
Technical data.
G
F
C
•
Fit the drive disc (B) on the output shaft.
•
Turn the output shaft until one of the holes in the drive
disc aligns with the corresponding hole in the gear
housing.
•
Insert the locking pin (C) in the hole to lock the shaft.
•
Place the blade (D) and support flange (F) on the
output shaft.
•
Fit the nut (G). The nut must be tightened to a torque
of 35-50 Nm (3.5-5 kpm). Use the socket spanner in
the tool kit. Hold the shaft of the spanner as close to
the blade guard as possible. To tighten the nut, turn
K
J
I
L
A
D
B