How To Disconnect The Batteries After Charging; Storage And Maintenance; Instructions On Using The Batteries - Invacare Mirage User Manual

Invacare® Mirage
WARNING!
Risk of injury if using the mobility device during
charging
– DO NOT attempt to recharge the batteries and
operate the mobility device at the same time.
– DO NOT sit in the mobility device while charging the
batteries.
1. Switch off the mobility device.
2. Connect the battery charger to the charger socket.
3. Connect the battery charger to the power supply.

7.2.4 How to disconnect the batteries after charging

1. Once charging is complete, first disconnect the battery charger
from the power supply, then disconnect the plug from the
remote.

7.2.5 Storage and Maintenance

Follow the instructions listed below to ensure safe use and longevity
of the batteries:
•
Always store the batteries fully charged.
•
Do not leave the batteries in a low state of charge for an
extended length of time. Charge a discharged battery as soon
as possible.
•
In case your mobility device is not used for a longer period
of time (that is more than two weeks), the batteries must be
charged at least once a month to maintain a full charge and
always be charged before use.
•
Avoid hot and cold extremes when storing. We recommend to
store batteries at a temperature of 15 °C.
•
Gel and AGM batteries are maintenance-free. Any performance
issues should be handled by a properly trained mobility device
technician.
42

7.2.6 Instructions on using the batteries

CAUTION!
Risk of damaging the batteries.
– Avoid ultra-deep discharges and never drain your
batteries completely.
•
Pay attention to the Battery Charge Indicator! Charge the
batteries when the Battery Charge Indicator shows that battery
charge is low.
How fast the batteries discharge depends on many
circumstances, such as ambient temperature, condition of the
surface of the road, tire pressure, weight of the driver, way of
driving and utilisation of lighting, if fitted.
•
Try to charge the batteries always before you reach the red LED
range.
The last 3 LED (two red and one orange) mean a remaining
capacity of about 15 %.
•
Driving with flashing red LED's means an extreme stress for the
battery and should be avoided under normal circumstances.
•
When only one red LED is flashing, the Battery Safe feature
is enabled. From this time, speed and acceleration is reduced
drastically. It will allow you to move the mobility device slowly
out of a dangerous situation before the electronic finally cuts off.
This is deep discharging and should be avoided.
•
Be aware that for temperatures below 20 °C, the nominal
battery capacity starts to decline. For example, at -10 °C
the capacity is reduced to about 50 % of the nominal battery
capacity.
•
To avoid damaging the batteries, never allow them to be fully
discharged. Do not drive on heavily discharged batteries if it is
not absolutely necessary, as this will strain the batteries unduly
and shorten their life expectancy.
•
The earlier you recharge the batteries, the longer they live.
1513283-M