Caller Specific Outgoing Announcement Feature Setup; Talking Caller Id Feature Setup - AT&T 900 MHz User Manual

Caller Specific Outgoing Announcement Feature Setup

Record personalized announcements — Caller Specific Outgoing
Announcements — that can be played to select callers. You can program
Caller Specific Outgoing Announcements to match:
• specific telephone numbers, or
• callers who choose to block their name and number when
calling (private calls), or
• callers from areas in which Caller ID information is not transmitted
(unknown calls).
Callers from the numbers and call types you designate will hear your
special announcement, not the "regular" announcement. You can set the
system to record callers' messages after your special announcement plays,
or to give information to callers without accepting messages (see Step 9 in
"Review Caller Specific Outgoing and Talking Caller ID Announcements" on
page 17).
You can program up to three Caller Specific Outgoing Announcements.
Each announcement can be up to three minutes long.

Talking Caller ID Feature Setup

You can also record announcements to be played at the base — Talking
Caller ID — when a call is received from a telephone number or call type
you program. The Talking Caller ID Announcement will play once, then the
phone will ring normally.
You can program up to 10 Talking Caller ID Announcements. Each
announcement can be up to five seconds long.
Record Caller Specific Outgoing and Talking Caller ID
Announcements from the Handset
1
Make sure the phone is off (
displayed).
2
Press U.
3 Use the softkey to select DIR.
4 Select ANS SYS.
FEATURE SETUP
is not
CALL ID
MEM
MENU
DIR
DIRECTORY
ANS SYS
15