Firebrick Replacement; Thermocouple Replacement - Quadra-Fire Adventure-III Owner's Manual

10. Please note that each tube is different in regards to the
amount and placement of air holes in each tube so there
is a specific order in which these need to be placed.
11. The Adventure III has 5 tubes total. 3 different size
tubes, the front tube, the 2nd tube and the back 3 tubes
which are the same. The 2nd tube and 3 back tubes
must be removed to remove the baffle.
12. Once the tubes are removed slide the insulation board
and ceramic blanket forward and then down in the back
and pull out.
13. To replace slide the board and ceramic blanket in from
the back and rest on the top front tube. Place the back
tube in first to help support the insulation board and
ceramic blanket.
14. Once in place, replace all of the remaining tubes and
remember to install the clips with each tube.
D. Firebrick Replacement
Replace the firebrick if they become crumbly and/or if there
is a 1/4 inch (6.35mm) or more gap between the bricks.
Inspect the firebrick after each ash removal.
The firebox is lined with high quality firebrick, which has
exceptional insulating properties. There is no need to use
a grate; simply build a fire on the firebox floor. Do not oper-
ate appliance without firebrick.
1. After the coals have completely cooled, remove all old
brick and ash from appliance and vacuum firebox.
2. Remove new brick set from box and lay out to diagram
shown on page 9.
3. Install lower rear bricks. Slide top of bricks under clip
on back of firebox wall and push bottom of brick back.
4. Lay bottom bricks in appliance.
5. Install side bricks. Slide top of brick under clips on side
of firebox and push the bottom of the brick until it is flush
with the side of the appliance.
CAUTION
Do not overtighten lock nut. The door handle needs to
move smoothly.
).
Quadra-Fire • Adventure-III Owner's Manual • 4083-900 • Rev D • 09/15
E. Thermocouple Replacement
1. To replace a thermocouple ensure the appliance is
completely cool
2. Unplug your appliance from the wall
3. Open the Control Access door
4. Remove the dust cover from the area below lifting up
and pulling out
5. Remove the thermocouple wire that you are replacing
from the control board by lifting up and pushing it back
through the grommet
6. Next open the appliance door, look for the thermocouple
in the top left or top right side of the firebox. Once located
remove the stainless steel thermocouple guard. You will
need a 3/16" Allen wrench to remove 2 screws.
7. Once the screws are removed the guards will come down
8. Next you will need to remove 2 screws from the side
panel of the appliance for the thermocouple that you are
replacing. The screws are found on the back side of the
appliance.
9. Once you remove the screws pull the shield out and
remove
10. The thermocouple will be on the top front portion of the
firebox side. You will need to remove two 3/8" self tap-
ping hex head screws to release the thermocouple.
11. Once these screws are removed pull the thermocouple
out until you feel resistance, then turn the thermocouple
at a 90 degree angle until you feel resistance again then
turn back another 90 degrees and pull it out all the way.
12. Pull the remaining wire out from the pedestal below
13. Now install the new thermocouple and wire, connect the
wire to the control board, then replace the thermocouple
guards and the firebox side shield.
14. Plug the appliance in and continue normal operation
25