Video Codec Tab - Sony SNC-CH110 User Manual

Video codec Tab

Set the items of Video 1 and Video 2 respectively for the
video codec.
However, in the case of monitoring using several
viewers, the frame rate or bit rate may be restricted.
The image may not be transmitted in some cases. If so,
set a lower frame/bit rate.
Cropping
You can crop a portion of the image and display the
cropped image on the computer. Cropping reduces the
transmitting data size and thus the network load, and a
higher frame rate is achieved.
Select On to crop the image, or Off.
Notes
• The motion detection function is not available when
Cropping is set to On.
• Cropping is not available when SolidPTZ is enabled.
• Video 2 image is cropped with the same setting as
Video 1.
• The maximum size of a cropped image is 1280 × 720
(SNC-CH210/DH210/DH210T)/1280 × 960
(SNC-CH110/DH110/DH110T) pixels.
• If the cropped image is large, depending on the types
of codec and frame rate set for Image 1, the Image 2
codec may be set to Off, or the frame rate may be
restricted.
32
Setting the Camera Image — Camera Menu
To crop an image
1
Set Cropping to On and click the Area setting
button.
The area setting window appears.
2
Setting the trimming portion
Hold down the left button of the mouse on the still
image and drag the cursor diagonally. The area in a red
frame is the trimming portion.
3
Click OK at the bottom of the window.
The cropped image is displayed on the main viewer.
4
To close the image, click
corner.
SolidPTZ
Select ON to enable the SolidPTZ function.
Notes
• SolidPTZ is not available when Cropping is enabled.
• When Aspect ratio in the System menu- Installation
tab is set to 16:9, this function is not available.
• When SolidPTZ is set to On, the motion detection
function is not available.
• When SolidPTZ of Image 1 is set to On, SolidPTZ
of Image 2 can be set to On.
SolidPTZ priority
When SolidPTZ is set to On, select Resolution or
Frame rate. When you use the SolidPTZ function,
select Resolution to zoom the image clearly, or select
Frame rate to shoot high-speed subjects.
Notes
• SolidPTZ priority setting is not available on the
SNC-CH110/DH110/DH110T.
• You cannot select SolidPTZ priority for Video 2
since the setting value for Video 1 is applied to Video
2.
Codec
Select JPEG, MPEG4, H.264 or OFF. Note that Image
1 cannot be set to Off.
Notes
• The selectable size of images and frame rate for
Image 2 may be limited depend on the setting of codec
type, size of images and/or frame rate for Image 1.
• Motion detection function is not available when Image
2 is set to other than Off.
in the upper-right