Operation; Before Startup - Kärcher K 4 Premium eco!ogic Operating Instructions Manual

Operation

Switch position "eco"
There are the switch positions "1/ON" and
"eco" to switch the appliance on.
Note: The switch position "eco" allows the
control of pressure and leads to water and
energy savings of approx. 20% by using the
spray lance.
Recommended application ranges for
switch position "eco"

Before Startup

Mount loose parts delivered with appliance
prior to start-up.
Illustrations on Page 13-14
Install wheels
Illustration
 Push the wheels into the intake.
 Secure the wheels using the included
plug. Align the plug properly!
Install the storage for trigger gun
Illustration
 Place the bottom holder into the recess-
es and push forward until it audibly
locks in.
 Insert the top holder and push down all
the way.
6 English
Install the storage hook for the mains
connection cable
Illustration
 Press in the storage hook and lock it
into the top position.
Install the transport handle
Illustration
You will need the 2 included screws as well
as a Phillips screwdriver PH 2.
 Slide the transport handle into the guide
and secure it with 2 screws.
Install the dosage regulator for
detergent
Illustration
You will need the 2 included screws as well
as a Phillips screwdriver PH 2.
 Insert both detergent hoses onto the
hose fittings.
 Install the dosage regulator and con-
nect using 2 screws.
Note: During installation you must make
sure that the tongues of the dosage regula-
tor match up with the intended recesses in
the casing.
Install the high pressure hose drum
Illustration
 Slide the free end of the coiled high
pressure hose through the recesses on
the dosage regulator.
 Insert the hose drum into the intakes on
the transport handle.
 Insert the axle of the hand crank into the
guides.
 Install the fixating plate and secure it
using 2 screws.
 Press the connecting fitting from the
short high pressure hose into the brass
intake, secure with clamps.
Note: Make sure the connection nipple is
aligned correctly.
Connect the high pressure hose to the
trigger gun
Illustration
 Push the high pressure hose into the
trigger gun until it locks audibly.
Note: Make sure the connection nipple is
aligned correctly.
 Check the secure connection by pulling
on the high pressure hose.