Maintenance - Panasonic SC-AKX50 Operating Instructions Manual

"VBR–"
"HI-SPEED CAN'T REC"
"DEVICE FULL"
System memory reset (Initialisation)
When the following situations occur, refer to the instructions below to reset the memory:
• There is no response when buttons are pressed.
• You want to clear and reset the memory contents.
To reset system memory
1 Disconnect the AC mains lead. (Wait at least 3 minutes before proceeding to step 2.)
2 While pressing and holding down [1] on the main unit, reconnect the AC mains lead.
"– – – – – – – –" appears on the display panel.
3 Release [1].
All the settings are returned to the factory preset.
You will need to reset the memory items.

Maintenance

If the surfaces are dirty
To clean this unit, wipe with a soft, dry cloth.
• Never use alcohol, paint thinner or benzine to clean this unit.
• Before using chemically treated cloth, read the instructions that came with the cloth carefully.
18
RQT804
AKX50_GN_EN.indd 18 AKX50_GN_EN.indd 18
• The unit cannot display the remaining play time for variable bit rate (VBR) tracks.
• You cannot use high-speed recording while using analogue mode. Change to digital mode
or use normal recording.
• You cannot perform recording because the total USB remaining REC (recording) time of
the USB device is less than the total time of the music source.
Change to a USB device which has the appropriate recording time and perform the
recording again.
Page
—
13
11
2/25/2010 10:21:38 AM 2/25/2010 10:21:38 AM