Real Time Transmission - Brother DCP-T300 Advanced User's Manual

Chapter 3
e
Press Mono Start.
Faxing from the ADF
 The machine starts scanning the
document.
Faxing from the scanner glass
When the LCD asks you Next Page?,
do one of the following:
 To send a single page, press 2 (or
press Mono Start again).
The machine starts sending the
document.
 To send more than one page, press
1 and place the next page on the
scanner glass.
Press OK.
The machine starts scanning the
page. (Repeat this step for each
page.)
After all the pages have been
scanned, press 2 or Mono Start to
begin faxing.
NOTE
• If you did not use up any of the numbers
for Groups, you can "broadcast" faxes to
as many as 90 different numbers.
• The machine's available memory will vary
depending on the types of jobs in the
memory and the numbers used for
broadcasting.
• If the Out of Memory message
appears, press Stop/Exit to cancel or
Mono Start to send the pages scanned so
far.
8
Cancelling a Broadcast in progress
a
Press Menu, 3, 5.
The LCD will show the fax number or
name being dialled and the
Broadcasting job number.
b
Press a or b to choose the Broadcasting
job number.
c
Press OK.
The LCD will ask you the following
question:
1.Clear 2.Exit
d
To cancel the broadcast, press 1.
e
Press Stop/Exit.

Real Time Transmission

When you are sending a fax, the machine will
scan the documents into the memory before
sending. Then, as soon as the telephone line
is free, the machine will start dialling and
sending.
Sometimes, you may want to send an
important document immediately, without
waiting for the machine to scan it into
memory. You can set Real Time TX to On
for all documents or Next Fax Only for the
next fax only.
Sending in real time for all faxes
a
Press (FAX).
b
Press Menu, 3, 2, 3.
c
Press a or b to choose On (or Off).
Press OK.
d
Press 2 so you can continue sending
your fax.
e
Load your document.
f
Enter the fax number.
g
Press Mono Start.
3
3
3