Product Specifications And Unpacking - Craftsman 315.212400 Owner's Manual

Blade Diameter
Blade Arbor
No Load Speed
Rating
Input
Net Weight
Your Miter Saw has been shipped completely
assembled except for the blade, miter lock handle, and
dust guide.
WARNING:
If any parts are missing, do not
operate this tool until the missing parts are
replaced. Failure to do so could result in possible
serious personal injury.
Remove all loose parts from the carton. Separate
and check with the list of loose parts. See Figure 2.
Remove the packing materials from around your
saw.
Carefully lift saw from the carton and place it on a
level work surface. This saw is heavy. To avoid
back injury, get help when needed.
PRODUCT SPECIFICATIONS
10 in.
5/8 in.
5000 RPM
120 Volts, 60 Hz-AC Only
13 Amperes
26 lbs.
UNPACKING
CAPACITY OF CUT
Max. Dimensional Lumber Size
Type of Cut
4 x 4
90˚ Cross Cut
2 x 4
2 x 6
4 x 4
45˚ Miter Cut
2 x 4
Do not discard the packing materials until you
have carefully inspected the saw, identified all
loose parts, and satisfactorily operated your new
saw.
Your saw has been shipped with the saw arm
locked in the down position. To release saw arm,
push down on top of saw arm and pull out the lock
pin. See Figure 4.
Hand pressure should remain on the saw arm to
prevent sudden rise upon release of the lock pin.
Examine all parts to make sure no breakage or
damage has occurred during shipping.
If any parts are damaged or missing, do not attempt to
plug in the power cord and turn the switch on until the
damaged or missing parts are obtained and are
installed correctly.
7
(Flat and Vertical)
(Flat and Vertical)