Mitsubishi Electric HC4900 User Manual page 28

Menu operation (continued)
4. SIGNAL menu
opt.
SIGNAL A V MEMO R Y 1
HORIZ. POSITION
VERT. POSITION
FINE SYNC.
TRACKING
COMPUTER
INPUT
R G B
R G B
OVER SCAN
HOLD
USER
4. SIGNAL menu
ITEM SETTING
HORIZ. POSITION 0 - 999
VERT. POSITION 0 - 999
FINE SYNC. 0 - 31
TRACKING 0 - 9999
COMPUTER INPUT AUTO
RGB
YC C
B
OVER SCAN 100 - 90%
HOLD OFF / ON
• Though horizontal strips may appear on the enlarged projected image, such symptom is not a malfunction.
• When you change the horizontal or vertical position to a large extent, noise may appear.
• The adjustable range of the vertical position varies depending on the type of the input signal. Though the image
may stay in the same position even when the setting value is changed, such symptom is not a malfunction.
• If you increase the OVER SCAN setting when viewing video signals, noise may appear on the screen. In this case,
decrease the OVER SCAN setting.
5. USER menu
ITEM SETTING
CLAMP POSITION 1 - 255
CLAMP WIDTH 1 - 63
VERT.SYNC AUTO / OFF
LPF ON / OFF
SHUTTER(U) 0 - 32
SHUTTER(L) 0 - 32
SHUTTER(LS) 0 - 95
SHUTTER(RS) 0 - 95
5. USER menu
USER
CLAMP
POSITION
CLAMP WIDTH
0
VERT. SYNC
0 ?
LPF
0
0
SHUTTER(U)
AUTO
SHUTTER(L)
100%
SHUTTER(LS)
ON
SHUTTER(RS)
OK
FUNCTION
Use to adjust the horizontal position of the projected image.
Use to adjust the vertical position of the projected image.
Use to eliminate fl ickering or blur, if it appears, while viewing the projected
image.
Use to eliminate vertical wide stripes, if it appears, while viewing the projected
image.
The proper setting is automatically selected.
Select this option when connecting the projector to high defi nition video
equipment having R, G, and B output terminals.
/ YP P Select this option when connecting the projector to a DVD player or other
R B R
device having Y, C
terminals.
Use to adjust the display area of the projected image when playing LD and
DVD discs.
Use to adjust the image when fl agging occurs near the top of the screen.
FUNCTION
Use to correct solid white or solid black in the projected image.
Use to correct solid black in the projected image.
Use to adjust the image when its motion doesn't run smoothly. Select AUTO for
normal use.
Use to select whether or not to enable the LPF.
Use to display the black bar on the top part of the image.
Use to display the black bar on the bottom part of the image.
Use to display the black bar on the left half of the image.
Use to display the black bar on the right half of the image.
1
1
AUTO
OFF
0
0
0
0
, and C (or Y, P , and P
B R B
EN-28
) component video output
R