Mitsubishi Electric WD-57732 Owner's Manual page 15

Front-Panel Indicators
Off Steady On
LAMP Indicator
LED Color TV Condition
Normal TV on or standby condition.
None
TV just powered off and lamp is
Green
cooling.
1. Lamp access door is open or
Yellow
not secure.
2. No lamp installed.
Lamp no longer illuminates and has
Red
reached the end of the lamp life.
STATUS Indicator
LED Color TV Condition
Normal TV on or standby condition.
None
Room temperature is too high.
Yellow
TV may require service.
Red
POWER/TIMER Indicator
LED Color TV Condition
TV is powered off.
None
TV is powered on.
Green
1. TV just plugged into AC outlet.
Green
2. AC just restored after power
failure.
3. TV Rebooting after System
Reset used.
4. TV Rebooting after power
fluctuation or receiving abnor-
mal digital signals from digital
channel, CableCARD™, or
digital device.
5. You have begun the procedure
to update software from an
authorized flash memory device.
TV powered off and auto-on timer
Green
is set.
Slow Blinking Fast Blinking
Additional Information
Normal operation.
Starts to blink 30 seconds after turning off TV. TV can be turned
on before blinking starts or after blinking stops, but not while the
indicator is blinking. Normal operation.
TV will not operate until lamp access door is secure. See Appen-
dix C for installation information.
TV will not operate without a lamp. See Appendix C for installa-
tion information.
Replace the lamp. The TV will not operate when the lamp no
longer illuminates. See Appendix C for installation information.
Additional Information
Normal operation.
TV will not operate when the ambient room temperature is too
high. Turn off the TV and wait until the room temperature drops.
Turn off the TV and unplug the set from the AC power source.
Wait one minute and then plug the set back in.
If the LED is still on, contact your dealer or a Mitsubishi Authorized
Service Center. See www.mitsubishi-tv.com or call 1-800-332-
2119 to receive Authorized Service Center information.
Additional Information
Normal operation.
Normal operation.
Wait until blinking stops before turning on (approximately 1
minute). Normal operation.
For detailed information, see the instructions that accompany the
authorized software update. Important: Do not use unauthorized
software at any time.
Normal operation. TV can be turned on at any time.
Chapter 1. Television Overview
15