Brother DCP-T300 Basic User's Manual page 50

Error Message
Cannot Print
Refill [XX] Ink
Clean Unable XX
Init Unable XX
Print Unable XX
Scan Unable XX
Close Ink Cover
Cover is Open
Data Remaining
Document Jam
(DCP-T700W)
High Temperature
42
Cause
The amount of remaining ink in one or
more of the ink tanks is low. The
machine will stop all print operations.
This error message may appear if the
ink dot counter is incorrect even if
some ink remains.
The machine has a mechanical
problem.
A foreign object, such as a paper clip
or a piece of ripped paper, is in the
machine.
The ink tank cover is not locked in the
closed position.
The scanner cover is not locked in the
closed position.
Print data is left in the machine's
memory.
The document was not inserted or fed
correctly, or the document scanned
from the ADF was too long.
The room temperature is too high.
Action
Refill the ink tank.
When you refill the ink tank, fill the ink
up to the upper line, or fill with all of
the ink in the bottle if it does not
exceed the upper line.
A message may appear on the LCD
to verify whether the ink tanks were
refilled.
Press a (Yes) to reset the ink dot
counter if ink tank has been refill.
Press b (No) if ink tank has not been
refilled.
(See Refilling the ink tanks
on page 33.)
Open the scanner cover and remove
any foreign objects and paper scraps
from inside the machine. If the error
message continues, disconnect the
machine from the power for several
minutes and reconnect it.
Firmly close the ink tank cover until it
locks into place.
Lift the scanner cover, and then close
it again.
Make sure the USB cable (if used)
has been guided correctly through the
cable channel and out the back of the
machine.
Press Stop/Exit. The machine will
cancel the job and clear it from the
memory. Try to print again.
(See Using the ADF (DCP-T700W)
on page 20.)
(See Document jam (DCP-T700W)
on page 46.)
After lowering the room temperature,
allow the machine to cool down to
room temperature and then try again.