Appendix 1- Diamond Shield
The custom-fitted Diamond Shield is an extra protection for your television screen. It has a subtle
tint that enhances picture contrast. It can be removed or installed, according to your preference.
Wear cotton gloves to prevent putting fingerprints on the Diamond Shield.
Removal of the Diamond Shield:
• to remove put a small piece of masking tape on the outward
• remove the retaining clips (2) with a small, flat blade screwdriver.
• after loosening retaining clip ends, gently pull out to remove clips
• gently pull Diamond Shield towards you, bowing the shield out of
• reinstall the retaining clips (2), if desired
Installation of the Diamond Shield:
• remove the retaining clips (2) with a small, flat blade screwdriver.
• after loosening clip ends, gently pull out to remove clips
• Bow Diamond Shield towards you and insert into locking chan-
• press in provided retaining clips (2) into place at ends first, then
•
side of the Diamond Shield. This will designate the special
scratch resistant side for later use
Press blade into opening at end of clips (Illustrations 1or 2) and
pry out
its locking channels (Illustration 3 or 4)
Press blade into opening at end of clips (Illustrations 1 or 2) and
pry out
nels (Illustrations 3 or 4)
towards center
your Diamond Shield is now installed
I M P O R T A N T
I M P O R T A N T
Store your Diamond Shield
so that the shield does not become
scratched.
TM
TM
carefully
77