HP 255 G4 Maintenance And Service Manual page 64

4. Use the following image to determine proper cable routing around the hinge.
(1): Display cable routing path
(2): Webcam cable routing path
(3): Antenna cable routing path
If it is necessary to replace any of the display assembly subcomponents:
1. To remove the display bezel:
a. Flex the inside of the top edge (1), the left and right edges (2), and the bottom edge (3) of the
display bezel until the bezel disengages from the display enclosure.
b. Remove the display bezel (4).
NOTE:
following image.
2. To remove the webcam/microphone module:
a. Position the display assembly with the top edge toward you.
b. Disconnect the cable (1) from the module.
56 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
In this procedure, the display will NOT be connected to the computer, as shown in the