Nokia N97 User Manual page 67

Select from the following:
Access point name — You obtain the access point name
from your service provider.
User name — The user name may be needed to make a data
connection, and is usually provided by your service provider.
Prompt password — If you must enter the password every
time you log in to a server, or if you do not want to save your
password in the device, select Yes.
Password — A password may be needed to make a data
connection and is usually provided by your service provider.
Authentication — Select
password encrypted or Normal
encrypted when possible.
Homepage — Depending on the access point you are setting
up, enter the web address or the address of the multimedia
message centre.
Use access point — Select
the device to ask for confirmation before the connection
using this access point is created, or
want the device to connect to the destination using this
access point automatically.
Select Options Advanced settings
>
following:
Network type — Select the internet protocol type to transfer
data to and from your device. The other settings depend on
the selected network type.
Phone IP address (for IPv4 only) — Enter the IP address of
your device.
Secure to always send your
to send your password
After confirmation if you want
Automatically
and from the
DNS addresses — Enter the IP addresses of the primary and
secondary DNS servers, if required by your service provider.
To obtain these addresses, contact your internet service
provider.
Proxy server address — Enter the address of the proxy
server.
Proxy port number — Enter the port number of the proxy
server.
WLAN internet access points
Select Menu
Destinations
To edit a wireless LAN (WLAN) access point, open one of the
access point groups, and select an access point marked with
.
Follow the instructions from your WLAN service provider.
Select from the following:
if you
WLAN network name — Select
for networks. If you select an existing network, WLAN
network mode and WLAN security mode are determined by
the settings of its access point device.
Network status — Define whether the network name is
displayed.
WLAN network mode — Select
network and to allow devices to send and receive data
directly; a WLAN access point device is not needed. In an ad
Settings and Connectivity
>
Access point, and follow the instructions.
>
Enter manually
Ad-hoc
Connectivity 67
>
or Search
to create an ad hoc