Power On/Off - Dukane 8230W User Manual

Power on/off

Turning on the power
1.
Make sure that the power cord is firmly
and correctly connected to the projector
and the outlet.
2.
Make sure that the POWER indicator is
steady orange (104).Then, remove the
lens cover.
3.
Press STANDBY/ON button on the
projector or the remote control. The
projection lamp lights up, and the POWER
indicator begins to blink green. When the
power is completely on, the indicator will
stop blinking and light in steady green
(104).
To display the picture, select an input signal according to the section Selecting an
input signal (23).
The INITIAL SETTING Menu will be displayed by factory default upon startup.
Once the INITIAL SETTING Menu is set, it will not appear until FACTORY RESET
(71) is executed. If you wish to change the settings, refer to the LANGUAGE
(52) and ALTITUDE (64) menu.
(1) LANGUAGE: Use the ▲/▼/◄/►
buttons to select the desired language
and press the ENTER button of the
remote control or the INPUT button of
the projector to execute.
(2) ALTITUDE: Use the ▲/▼ buttons to
select NORMAL for altitude below 1600
m (5250 feet), otherwise select HIGH
and press the ENTER button of the
remote control or the INPUT button of
the projector to execute.
(continued on next page)
20
Power on/off
STANDBY/ON button
POWER indicator
STANDBY/ON INPUT MENU
INPUT IWB CALIBRATION
ASPECT AUTO ACCENTUALIZER HDCR
D-ZOOM
- +
PAGE VOLUME
MAGNIFY MYBUTTON
UP ON 1 ＋
2 ー
DOWN OFF
KEYSTONE TEMPLATE FREEZE AV MUTE
ESC MENU
ENTER
POSITION RESET
LAMP
TEMP
POWER