Before Calling For Service - Mitsubishi CP900DW Operation Manual

TROUBLESHOOTING
2
Use the following troubleshooting chart to try to resolve any apparent defect in operation. If you are unable to resolve the
problem, unplug the power cord and contact your dealer.
Symptom
No power
(when POWER lamp does not illuminate)
The image is not printed.
The stored image in the memory cannot be
enlarged to fill the maximum print area.
COPY button does not work.
Though the print paper is not left at the
print outlet, PAPER indicator blinks and
DATA indicator goes on.
18

BEFORE CALLING FOR SERVICE

Check and Remedy
Is the power cord plug disconnected from the outlet?
Connect the power cord plug to the outlet firmly.
After tuning the power off, wait for approx. 2 minutes. Then turn on the
power.
Is the image data sent to this unit?
Is the print paper or ink sheet used up?
Is the printing mechanism set correctly?
Check the status.
Is the appropriate image data transferred?
Is the S-size image data sent for L-size print paper?
Check the status.
Is the image data transferred?
Send an image data.
If the power is turned off and then turned on after sending the data, the
COPY button does not work.
The sensor for detecting remaining paper may fail to work properly due
to infrared light and so on.
Set the mode switch No. 7 on the rear panel to ON.