Setting Mode Switches - Mitsubishi CP900DW Operation Manual

CONNECTIONS
2 2 2 2 2

SETTING MODE SWITCHES

Set the mode switches on the rear panel according to the equipment connected.
All the switches are set to OFF as shown right when shipped from the factory.
Turn off the power when changing the mode switch settings.
With the switch No.1 and No. 2, the printing speed can be set.
Switch No.
Print speed
1 2
OFF OFF Prints at the speed set by the printer driver
ON ON
OFF ON FINE mode print
ON OFF FAST mode print
With the switch No.3 to No. 8, the following can be set.
Switch No. Settings Functions
3 OFF Uses the normal gamma curve of images
ON Uses the gamma curve for connecting to ultrasound diagnostic equipment
4 OFF Normal print
ON Mirror print
5 OFF Prints with surface coating
ON Prints without surface coating
6 OFF Not used (Set this switch to OFF.)
7 OFF When the printed paper remains at the print outlet, PAPER indicator blinks and this unit stops printing.
ON Even if the printed paper remains at the print outlet, PAPER indicator remains turned off and this unit
does not stop printing.
8 OFF Automatic feed&cut mode
This will cause the printer to perform an automatic feed and cut after installation of the paper and ink
sheet.
ON Manual feed&cut mode
10
SETTING MODE SWITCHES
8 7 6 5 4 3 2 1
OFF
ON