Using The Tv Guide On Screen System - Mitsubishi WD-57833 Owner's Manual

Dlp high-definition television

Hide thumbs Also See for WD-57833:

Specification sheet (6 pages)

Owner's manual (95 pages)

Service manual (84 pages)

Table Of Contents

Table of Contents

5. TV Menu Settings

Inputs Menu

Setting Up TV Guide On Screen

Setup of the TV Guide On Screen system is optional.

• You must set up NetCommand control of a VCR

or A/V disc for recording if you wish to enable

recordings through TV Guide On Screen.

• Many features of TV Guide On Screen are

available without NetCommand control. For

example, program listings, program searches,

and program reminders function without

NetCommand.

1. Display the Inputs > Guide menu to display TV

Guide On Screen setup options.

2. To enable the TV Guide On Screen system, high-

light On. If you wish to disable the system, high-

light Off.

Inputs > Guide menu for TV Guide On Screen setup

3. Select program sources for the listings. You can

select one over-the-air source or one direct-cable

IMPORTANT

• After setup, it may take up to 24 hours to start

receiving program listings and then it may take up

to one week to receive all eight days of listings.

•

Leave the TV powered off for a while each day to

allow new listings to download.

source for TV Guide On Screen. If, however, you

have multiple cable sources, the channel-number

assignments may not match up correctly. See the

following table and notes for the preferred connec-

tion combinations.

If One Source Is:

Ant-1 Channels via Cable

Ant-2 Channels via Cable

Note:

• Inputs to TV Guide On Screen can include only one

over-the-air source or only one direct-cable source.

• TV Guide On Screen listings can be downloaded

from an over-the-air antenna or direct cable con-

nected to ANT 1 or ANT 2.

4. Highlight the ZIP Code digits and enter the five-

digit ZIP code for your location. To receive the

correct program listings for your area, you must

enter the ZIP code.