Samsung SC18AS0 Service Manual page 8

No Parts
2 Electrical Parts
(Main PCB)
3 Tray Drain
4 Heat Exchanger
Samsung Electronics
Procedure
1) Take all the connector of PCB upper side
out.(Including Power Cord)
2) Detach the outdoor unit connection wire
from the Terminal Block.
3) If pulling the main PCB up. It will be taken
out.
1) Pull Tray Drain out from the Back Body.
1) Loosen 2 fixing earth screws of right side.
2) Detach the Connection Pipe.
3) Detach the Holder Pipe at the rear side.
4) Loosen 2 fixing screws of right and left
side.
5) Lifting the Heat Exchanger up a little
to push the up side for detach from the
indoor unit.
Disassembly and Reassembly
Remark
7