Selecting Area For Installation - Samsung SC18AS0 Service Manual

2-2 Installation

2-2-1 Selecting Area for Installation

Select an area for installation that is suitable to the
customer's needs.
2-2-1(a) Indoor Unit
1. Make sure that you install the indoor unit in an area
providing good ventilation. It must not be blocked by an
obstacle affecting the airflow near the air inlet and the air
outlet.
2. Make sure that you install the indoor unit in an area
allowing good air handling and endurance of vibration of
the indoor unit.
3. Make sure that you install the indoor unit in an area
where there is no source of heat or vapor nearby.
4. Make sure that you install the indoor unit in an area from
which hot or cool air is spread evenly in a room.
5. Make sure that you install the indoor unit in an area away
from TVs, audio units, cordless phones, fluorescent light-
ing fixtures and other electrical appliances (at least 1
meter).
6. Make sure that you install the indoor unit in an area
which provides easy pipe connection with the outdoor
unit, and easy drainage for condensed water.
7. Make sure that you install the indoor unit in an area
which is large enough to accommodate the measure-
ments shown in figure on the next page.
2-2-1(b) Outdoor Unit
1. Make sure that you install the outdoor unit in area not
exposed to the rain or direct sun light.
(Install a separate sunblind if exposed to direct sun light.)
2. Make sure that you install the outdoor unit in area allow-
ing good air moment, not amplifying noise or vibration,
especially to avoid disturbing neighbors. (Fix the unit
firmly if it is mounted in a high place.)
• It is harmful to the air conditioner if it is used in the following environments: greasy areas (including areas near
machines), salty areas such as coast areas, areas where sulfuric gas is present such as hot spring areas.
Contact your dealer for advice.
Samsung Electronics
3. Make sure that you install the outdoor unit in area provid-
ing good ventilation and which is not dusty. It must not be
blocked by any obstacle affecting the airflow near the air
inlet and the air outlet.
4. Make sure that you install the outdoor unit in area free
from animals or plants.
5. Make sure that you install the outdoor unit in area not
blocking the traffic.
6. Make sure that you install the outdoor unit in area easy to
drain condensed water from the indoor unit.
7. Make sure that you install the outdoor unit in area which
provides easy connection within the maximum allowable
length of a coolant pipe(18
Note
1. Add (18 : 20g, 24
every 1 meter if the pipe length exceeds the standard
pipe length of 7.5 meters.
2. Maintain a height between the indoor and outdoor units
of less than 8 meters.
8. Make sure that you install the outdoor unit in an area
which is large enough to accommodate the measure-
ments.
2-2-1(c) Remote Control Unit
1. Make sure that you install the remote control unit in an
area free from obstacles such as curtains etc, which may
block signals from the remote control unit.
2. Make sure that you install the remote control unit in an
area not exposed to direct sunlight, and where there is no
source of heat.
3. Make sure that you install the remote control unit in an
area away from TVs, audio units, cordless phones, fluo-
rescent lighting fixtures and other electrical appliances (at
least 1 meter).
:15meters, 24 :20meters).
: 30g) of refrigerant (R410A) for
5