Samsung SC18AS0 Service Manual page 13

Set Up the Model Option
7
8
9
10
11
12
Setting is not required if you must
a value which has a
Step 3 : Upon completion of the selection, check you made right selections.
Press the Mode Selection key,
The display part shows
Press the Mode Selection key,
The display part shows
Step 4 : Pressing the ON/OFF button (
When pressing the operation ON/OFF key with the direction of remote controller for unit, the sound ''Ding'' or ''Diriring'' is
heard and the OPERATION ICON(
pleted. (If the diriring sound isn't heard, try again pressing the ON/OFF button.)
Step 5 : Unit operation test-run
First, Remove the battery from the remote controller.
Second, Re-insert the battery into the remote controller.
Third, Press ON/OFF key with the direction of remote controller for set.
• Error Mode
1 st If all lamps of indoor unit are flickering, Plug out, plug in battery again and press ON/OFF key to retry.
2 If the unit is not working properly or all lamps are continuously flickering after setting the option code, see if the correct option code is
nd
set up for its model.
12
7
Press
8
Push the
Every time you push the button, the display panel reads
9
Push the
Every time you push the button, the display panel reads
10
Push the
Every time you push the button, the display panel reads
11
Push the
Every time you push the button, the display panel reads
12
Push the
Every time you push the button, the display panel reads
default.
to set the display part to
.
to set the display part to
.
)
) lamp of the display is flickering at the same time, then the input of option is com-
button, then the default value is
button to set the display panel to
. . .
button to set the display panel to
. . .
button to set the display panel to
. . .
button to set the display panel to
. . .
button to set the display panel to
. . .
and check the display part.
and check the display part.
.
.
repeatedly.
.
repeatedly.
.
repeatedly.
.
repeatedly.
.
repeatedly.
Samsung Electronics