Craftsman 917.20392 Operator's Manual page 23

5. INSTALL ANTI-SWAY BAR (S) +
(IF EQUIPPED)
_AY BAR (S) 1
Towards Towards "_b,_l
nsaxle Mower Deck _'-I
%
9 0 ° End Integrated Washer End
From right side of mower, first insert
90 ° end of anti-sway bar (S) into hole in
transaxle bracket ('t"), located near left _ D__wer Bracket
rear tire in front of transaxle. [' S. Anti-Sway Bar I
T. Transaxie
NOTE: Flashlight may be helpful. I . Bracket , I
6. ATTACH MOWER SIDE SUSPENSION
Anti-Sway : '_ - "- .... ARMS (A) TO CHASSIS
" +_<'; ; "- • Positionfrontholeinsidesuspensionarm
Bar(S) _" - _ _ i - \ (A)overpinonoutsideoftractorchassis
...... '\_L_ 'i__"_-_ "_,.. _ _', and secure with large washer and large
' -<-" _ retainer spring (B).
• Repeat on opposite side of tractor.
Transaxle _ _r tl
Located Between Rear Tires
J
A.
B.
D.
Mower Side Suspension Arms
Retainer Spdng
Right Side Rear Mower Bracket
NOTE: Depending on model, bracket (T) may
be different than shown but hole for anti-sway
bar will be in same position/location.
Ptvot the integrated washer end of anti-
sway bar (S) towards mower deck bracket
on right side of mower. Insert integrated
washer end of bar into hole in rear mower
bracket (D). Move mower as needed to
insert integrated washer end of bar into
rear mower bracket (D).
Secure with small washer and small
retainer spring as shown.
7. ATTACH REAR LIFT LINKS (C)
• Insert rod end of rear lift link (C) into hole
(U) in tractor lift shaft suspension arm
and pivot link down to mower.
• Lift rear corner ofmower and position slot
in link assembly over pin on rear mower
bracket (D) and secure with large washer
and large retainer spring.
• Repeat on opposite side of tractor.
23