Electrical Safety; Assembly And Adjustments; Operation; Maintenance - DeWalt DWB800 User Manual

experience, knowledge or skills unless they are
supervised by a person responsible for their
safety. Children should never be left alone with
this product.

Electrical Safety

The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
Your D WALT tool is double insulated in
E
accordance with EN 60745; therefore no
earth wire is required.
WARNING: 127 V units have to
be operated via a fail-safe isolating
transformer with an earth screen
between the primary and secondary
winding.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
D WALT service organisation.
E
Mains Plug Replacement
(Middle East and Africa)
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in
the plug.
• Connect the blue lead to the neutral terminal.
WARNING: No connection is to be
made to the earth terminal.
Follow the fitting instructions supplied with good
quality plugs. Recommended fuse: 13 A.
Using an Extension Cable
If an extension cable is required, use an approved
3–core extension cable suitable for the power input
of this tool (see Technical Data).The minimum
2
conductor size is 1.5 mm ; the maximum length
is 30 m.
When using a cable reel, always unwind the cable
completely.

ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing set-
ups or when making repairs. Be sure
the trigger switch is in the OFF position.
An accidental start-up can cause injury.
Mounting the Nozzle for Blowing
Operations (fi g. 1)
Insert the pin located inside the nozzle (a) into the
notch provided on the blast port (b)
To lock nozzle in place, turn the nozzle in the
direction indicated.
To remove nozzle, turn the nozzle in the opposite
direction.
Mounting the Nozzle and Dust Bag
for Dust Collection (fi g. 2)
For dust collection, mount the dust bag at the blast
port (b) and nozzle at the suction port (f).
To remove dust bag and nozzle, simply pull out by
first turning in the opposite direction.
Empty the dust bag frequently to ensure maximum
dust collecting efficiency.

OPERATION

Instructions for Use
WARNING: Always observe the safety
instructions and applicable regulations.
Operating the Blower (fi g. 1, 3)
• To switch your blower on, depress the switch
(c). To stop your blower, release switch.
• Adjust variable speed knob (d) for different
speed requirement.
• When continuous operation is required, first
depress the switch and then the lock-on button
(e) and release to disengage lock, squeeze and
release switch.
WARNING: Continuous running of
machine should not exceed 30 minutes.

MAINTENANCE

Your D WALT power tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing
set-ups or when making repairs.
Be sure the trigger switch is in the OFF
position. An accidental start-up can
cause injury.
EN GL IS H
5