Change Supervisor/User Password; Auto-Detect Hard Disk - Xycom SBC-370 User Manual

CHANGE SUPERVISOR/USER PASSWORD

Set a password that is used to protect your system and Setup Utility. Supervisor Pass-
word has higher priority than User Password. Once you setup the password, the system
will ask you to enter the password every time you enter the BIOS SETUP. If you enter the
BIOS SETUP with the Supervisor Password, you can access every setup option on the
main menu. With a User Password, you can only choose three setup options (
Password, Save Setting and Exit
BIOS SETUP menu with the Supervisor Password and then press the
entering a new password when the

AUTO-DETECT HARD DISK

This option detects the parameters of an IDE hard disk drive (HDD sector, cylinder,
head, etc.) automatically and will put the parameters into the Standard CMOS Setup
screen. Up to 4 IDE drives can be detected and the parameters will be listed in the
box. Press
Note:
be detected. In this case, you need to enter the correct parameters manually or low-level
format the disk.
39
, and
if you accept these parameters. Press
Y
If your IDE HDD was formatted in a previous system, incorrect parameters may
). To disable these passwords, enter the
Exit Without Saving
prompt appears.
Enter Password
N
BIOS Setup Menus
key instead of
Enter
to skip to the next IDE drive.
Change User