Sym DD 50 Service Manual page 129

13. STEERING/FRONT WHEEL/SUSPENSION
Remove wheel hub from wheel rim after 4 nut
removed.
Remove dust seal, bearing and side collar.
Special tools
Inner bearing puller (SYM-6204020)
Installation
Fill out the block of bearing by grease.
Drive the left bearing and install the dist. collar.
Install the right bearing.
Caution
Carefully install the bearing in correct and
evenly.
Bearing outer face should be faced up as
bearing installation.
Install the brake disc and then tighten the bolts
(disc brake).
Torque value: 4.5kgf-m
13-6
This chapter Contents
DISK TYPE
Dust seal
DRUM TYPE
Bearing
Dist. collar
Bearing
Dust seal
Bearing
Bolts
Dust seal
Dist. collar