Mitsubishi G-50A Operating Manual page 7

Notice
During database setting, the process may be observed as stopped for a while. However, it is still under
operation internally. Wait for some time until "Press any key to continue - - - -" appears without doing
anything.
*Do not stop the set up procedure by pressing
Step 3) Setting up the Maintenance Tools
Set up the application of this Maintenance Tools . Please read the guide shown on the screen carefully
to proceed the setting up.
(1) Starting the setup program
1) Start setup.exe.
Execute "setup.exe" located in
SetUp ¥3_MNTTOOL folder of CD-ROM.
Double clicking on "setup.exe" with the explorer displays
"Welcome" screen. Please confirm the caution shown on
the screen before setting up.
2) Confirm the display contents, and select [Next] button.
If no problem was found on the content, click [Next] button.
* To stop setting up, click on [Cancel] button.
(2) Confirming the Installation folder
1) Confirm the installation folder and select [Next] button.
Confirm the folder on which this program should be
installed. To change the installation folder (C drive only),
Use [Previous] button. After confirming the installation
folder, click on [Next] button.
* Clicking on [Cancel] button stops installation procedure.
(3) Confirming the installation start
1) Confirm the starting and select [Next] button.
Clicking on [Next] button starts installation.
* Clicking on [Cancel] button stops installation.
(4) Confirming the completion of Maintenance Tools setup
1) Select [Close] button.
Click on [Close] button on the Installation Complete screen.
After completing installation, restart your computer.
Keep the CD-ROM used with you carefully.
Request
•After installing Maintenance Tools, be sure to restart
your computer.
at the upper right of the screen.
6