AT&T 959 User Manual page 43

2 Connect the long telephone line cord to the jack labeled TEL
on the back of the phone.
3 Connect the line cord to a modular wall jack.
4 Connect the handset to the telephone.
Plug the coiled handset cord into the handset jack on the left
side of the phone. Plug the other end of the coiled cord into the
handset, then hang up.
handset jack
5 Check for dial tone.
Lift the handset and listen for a dial tone. If you cannot hear
a dial tone, press VOLUME +. If you still do not hear a dial tone,
see the IN CASE OF DIFFICULTY beginning on page 34 of your User's
Manaul, Part 2.
Your phone will work immediately after installation using the default feature
settings (See "Default Settings" on page 31 of you User's Manual, Part 2).
NOTE: If you subscribe to Caller ID services from your local telephone
service provider, you must follow the instructions in "Set Home Area Code"
for your phone to properly recognize and dial calls (see page 5). You may also
need to "Set Local Area Codes" (see page 6).
Modular
telephone
wall jack
Telephone
line cord
3