Sears 721.36078600 Repair Services page 12

WARNING
Electrical Shock or Personal Injury Hazard
Disconnect electrical supply before servicing or cleaning the unit. Failure to do so could result in electrical
shock or personal injury from the vacuum cleaner suddenly starting.
Check the bag from time to time. When excessive dirt
accumulates, the cleaner may not operate effectively.
If the cleaner does not seem to have adequate
suction, check the bag.
DISCONNECT THE CLEANER FROM
THE ELECTRICAL OUTLET.
Pull the dust cover grip forward and remove the dust
cover from the cleaner.
Grasp the dust bag collar and pull it out.
Attach a new dust bag onto the bag holder holding the
dust bag collar and pushing back as shown in the
figure.
Insert the tabs on the bottom of dust cover into the
grooves on the dust compartment.
Rotate the dust cover up into the closed position and
press it until the hook snaps into place.
The motor safety filter is located inside the dust
compartment. When installing or changing the dust
bag, always check this filter. When the filter becomes
dirty, clean it or install a new one.
To remove this filter, open the dust cover and pull the
filter out from the bottom of dust compartment.
To clean the old filter, rinse it in water and dry it.
Slide this filter back into place. It should be fully
inserted into the ribs of the bottom of dust
compartment. Be sure the filter is dry.
g
Dust
Cover
Dust
Bag
12
MODEL 721.36078600