Replacing Tires And Wheels; Parking Brake - Toyota 4Runner 2006 Owner's Manual

Reorient or relocate the receiving an-
D
tenna.
Increase the separation between the
D
equipment and receiver.
Connect the equipment into an outlet
D
on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced
D
radio/TV technician for help.
FCC WARNING:
Changes or modifications not
pressly approved by the party respon-
sible for compliance could void the
user's authority to operate the equip-
ment.
For vehicles sold in Canada
Operation is subject to the following two
conditions:
(1) this device may not cause interfer-
ence, and (2) this device must accept
any interference, including interference
that may cause undesired operation of
the device.
194
'06 4Runner_U (L/O 0508)

—Replacing tires and wheels

When replacing the wheels, be sure to
install air pressure sensors
wheels.
There are 3 ways to set up the air pres-
sure sensors:
a. Remove the sensor from the old wheel
and install it to the new wheel.
b. Keep the same wheel with air pressure
sensor and replace only the tire.
c. Use a new wheel and sensor. In this
case, you have to register an ID code
ex-
for a new sensor.
CAUTION
Have the tires, wheels or sensors re-
placed and ID codes registered by a
Toyota dealer. If you need sensors,
purchase from a Toyota dealer.

Parking brake

on the
When parking, firmly apply the parking
brake to avoid inadvertent creeping.
To set: Fully depress the parking brake
pedal. For better holding power, first de-
press the brake pedal and hold it while
setting the parking brake.
To release: Depress the parking brake
pedal once again.
To remind you that the parking brake is
set, the parking brake reminder light in
the instrument panel remains on until you
release the parking brake.