Touchscreen) - Chevrolet 2016 Traverse Owner's Manual

To calibrate the compass, use the
following procedure:
Compass Calibration Procedure
1. Before calibrating the compass,
make sure the compass zone
is set to the variance zone in
which the vehicle is located.
See Compass Variance (Zone)
Procedure earlier in this
section.
Do not operate any switches
such as window, sunroof,
climate controls, seats, etc.
during the calibration
procedure.
2. Press the vehicle information
button until PRESS
CALIBRATE COMPASS
displays.
3. Press the set/reset button to
start the compass calibration.
4. The DIC will display
CALIBRATING: DRIVE IN
CIRCLES. Drive the vehicle in
tight circles at less than 8 km/h
(5 mph) to complete the
calibration. The DIC will display
CALIBRATION COMPLETE for
a few seconds when the
calibration is complete. The
DIC display will then return to
the previous menu.
Clock (Radio without

Touchscreen)

To adjust the time and date:
1. Turn the ignition key to ACC/
ACCESSORY or ON/RUN,
then press
radio on.
H
2. Press
MM, DD, YYYY (hour, minute,
month, day, and year).
3. Press the pushbutton located
TO
under any one of the labels to
be changed.
4. To increase the time or date,
do one of the following:
Press the pushbutton below
the selected label.
Press
Press
Turn
Instruments and Controls
to turn the
to display HR, MIN,
SEEK.
FWD.
f
clockwise.
5. To decrease the time or date,
do one of the following:
Press SEEK.
Press REV.
f
Turn counterclockwise.
To change the time default setting
from 12 hour to 24 hour or to
change the date default setting from
month/day/year to day/month/year:
H
1. Press and then the
pushbutton located under the
forward arrow that displays on
the radio screen until the time
12H (hour) and 24H (hour), and
the date MM/DD (month and
day) and DD/MM (day and
month) display.
2. Press the pushbutton located
under the desired option.
H
3. Press again to apply the
selected default, or let the
screen time out.
113