Function introduction for combination buttons
Child lock function:
Press "+"and "-" simultaneously to turn on or turn off child lock function. When child
lock function is on,"
controller, it won't send signal.
Temperature display switchover function:
Under OFF status, press "-" and "MODE" buttons simultaneously to switch temperature
display between ℃ and ℉ .
Operation guide
1. After putting through the power, press "ON/OFF" button on remote controller to turn on
the air conditioner.
2. Press "MODE" button to select your required mode:AUTO, COOL, DRY, FAN, HEAT.
3. Press "+" or "-" button to set your required temperature. (Temperature can't be
adjusted under auto mode).
4. Press "FAN" button to set your required fan speed: auto, low, medium and high speed.
5. Press "
" button to select fan blowing angle.
Replacement of batteries in remote controller
1. Press the back side of remote controller marked with
"
"
of battery box along the arrow direction.
2. Replace two 7# (AAA 1.5V) dry batteries, and make
sure the position of "+" polar and "-" polar are correct.
3. Reinstall the cover of battery box.
Note:
● During operation, point the remote control signal sender at the receiving window on indoor
unit.
● The distance between signal sender and receiving window should be no more than 8m, and
there should be no obstacles between them.
telephone; remote controller should be close to indoor unit during operation.
● Replace new batteries of the same model when replacement is required.
● When you don't use remote controller for a long time, please take out the batteries.
● If the display on remote controller is fuzzy or there's no display, please replace batteries.
" icon is displayed on remote controller. If you operate the remote
signal sender
12
battery
reinstall
remove
Cover of battery box