Net Sonde Setting - Furuno FCV-1200L Installation Manual

3.6

Net Sonde Setting

Follow the procedure below when a Net Sonde is connected to the video sounder.
1. Turn on the power and turn the [FUNCTION] switch to the MENU position.
2. Press [ ] and [+] to select SYSTEM at the top of the screen.
3. Press [ ] to select NET SONDE SETTING, and then press [+] to open that menu.
4. The cursor is selecting SONDE MARK; press [+] to open the dialog box.
OFF LF HF
5. Use [+] or [-] to select where to display the sonde marker: OFF, no sonde marker displayed;
LF, low frequency picture, HF, high frequency picture.
6. Press [ ] or [ ] to close the dialog box.
7. Press [ ] to select COLOR, and then press [+] to open the dialog box.
1 2 3
8. Use [+] or [-] to select echo level to display, and then press [ ] or [ ] to close the dialog box.
1: Echo of color level 14 (Reddish-brown in standard color arrangement, default setting)
2: Echo of color level 12 (Red in standard color arrangement)
3: Echo of color level 10 (Orange in standard color arrangement)
3-14
DISP ALM TX/RX USER-1/2
NET SONDE SETTING
SONDE MARK :
COLOR : 1
SONDE GRAPH : OFF
GRAPH MODE : SURFACE
GRAPH WIDTH : 1/4
GRAPH RESET : NO
Indication of sonde mark.
[-/+]: Change set, [EXIT (knob)]: Exit
Figure 3-9 NET SONDE SETTING menu
SYSTEM
OFF