Master TENTEvent125 TB116A Owner's Manual page 10

Wheels and Axle
1. Locate wheels, washers, cotter pins and
axle in hardware packet.
2. Carefully slide axle through heater body
as shown in Figure 5.
3. Slide one wheel and washer onto axle.
Insert cotter pin into end of axle. See
Figure 5.
4. Repeat steps 2 and 3 for second wheel,
washer and cotter pin on other side of
heater.
Top
1. Remove 4 brackets, (8) 1/2" black screws
and (8) 3/8" screws from hardware
packet.
2. Lay top upside down on a clean surface.
Attach 4 brackets to top with 1/2" black
screws.
Bracket
Slots
10
aSSeMBLy
Continued
Washer
Figure 5 - Installing Axle and Wheels
3. Turn top over and carefully place over
4. Attach brackets to heater with 3/8" screws.
Figure 6 - Attaching Top
www.desatech.com
Heater
Front
Cotter Pin
heater, positioning brackets through slots
in heater front and rear panels.
Top
Bracket
Axle
Wheel
Bracket
Screws
120942-01E