[990][001 - 005] Show All Devices; [999] Reset To Factory Defaults; Placement Testing Wireless Devices - DSC HSM2HOST Installation Manual

H S M 2 H O S T I n s t a l l a t i o n M a n u a l
2. Press [*] to select a sub-section. The first available device is displayed.
3. Select a device to replace using the scroll keys or go to a specific device by entering a hotkey.
4. Press [*]. When prompted, activate the device (full enrollment) or enter the device ID (pre-enrollment). A message is displayed confirming
enrollment.
3.2.9 [804][990][001 – 005] Show All Devices
Use this section to review wireless devices enrolled on the system and to view serial numbers associated with each device.
To review wireless device information:
1. Enter Installer Programming section [804][990] then select one of the following sub-sections:
Table 3-10: Show all Device Options
Sub-Section
[001] All zones
[002] Repeaters
[003] Sirens
[004] Wireless keys
[005] Keypads
2. Press [*] to select a wireless device type. The first available device is displayed.
3. Use the scroll keys to view the enrolled devices.
NOTE: This option is not fully supported by LED and ICON keypads.

3.2.10 [804][999] Reset to Factory Defaults

Selecting this option resets HSM2HOST programming to factory default settings.

3.2.11 [904] Placement Testing Wireless Devices

This test is used to determine RF signal status for wireless devices and can be performed at a system keypad or at the individual device. These
instructions pertain to testing at the keypad. For instructions on placement testing at the device, refer to the installation sheet provided with the
wireless equipment. The following test modes are available:
Table 3-11: Wireless Device Placement Test Modes
[904][001]-[128] Test wireless zones
[904][521]-[528] Test all repeaters
[904][551]-[566] Test all sirens
[904][601]-[632] Test all wireless keys Test individual wireless keys. Once in this section, press a button on the wireless key to begin the test.
[904][701]-[716] Test all keypads
Two test results are provided:
• 24-hour: Average results of signal strength testing over a 24-hour period.
• Now: Signal status results of the current test.
A flashing Trouble LED indicates RF interference. The following status indicators may be displayed:
Table 3-12: Wireless Device Status Indications
LCD Icon* LED+
Strong 1 9 Strong signal strength
Good 2 10 Good signal strength
Poor 3 11 Poor signal strength
Not Test 5 13 Displayed as the Now result if no test was performed.
Not Test 14 Always displayed as the 24-hour result when testing wireless keys. Repeater 6
*For Icon keypads, digit 1 indicates 24-hour test results; digit 2 indicates Now test results.
+For LED keypads, the first digit indicates 24-hour results; the second digit indicates Now test results.
Description
Test wireless devices individually by zone.
NOTE: Zones with vanishing contacts must be activated to placement test.
Test each enrolled wireless repeater.
521-528 for repeaters 1-8
Test each enrolled wireless siren.
551-566 for sirens 1-16
601-632 for wireless keys 1-32.
Test each enrolled keypad
701-716 for keypads 1-16
Status
W i r e l e s s D e v i c e S e t u p a n d P r o g r a m m i n g
Repeater [905]
Repeater 1
Repeater 2
Repeater 3
Repeater 5
10