Previewing The Alarm And Turning The Alarm On/Off - iHome iBT230 Instruction Manual

Setting and Using the Alarms (Continued)
1. Press and hold the Alarm Button for 2 seconds until the alarm time display and alarm icon flash. A
beep sounds.
2. Press the or
Make sure you set the correct AM/PM alarm time. The AM and PM indicators appear to the left of
the display.
3. Press the Alarm Button to confirm the alarm time setting. The wake-to source will flash.
4. Press the or
Wake to Bluetooth: You will wake to the currently linked Bluetooth device. If no device is
Wake to Radio: Press the Alarm Button to confirm. Press the Presets Button to select an FM preset
Wake to Buzzer: You will wake to buzzer.
5. Press the Alarm Button to confirm the alarm settings and exit alarm setting mode. 2 beeps will confirm
alarm setting is complete. The alarm icon will remain on the display, indicating the alarm is armed.
6. To turn off a sounding alarm and reset it to come on the next day at the same time, press the
Power/Alarm Reset Button or the associated alarm button (

Previewing the Alarm and Turning the Alarm On/Off

Press and release the desired Alarm Button as needed to toggle the alarm ON (indicated by the alarm icon)
or OFF (no alarm icon).
Buttons to adjust the alarm time to the desired time (hold for rapid setting).
Buttons to select the desired wake to alarm source: Bluetooth, radio or buzzer.
detected, the alarm will default to buzzer.
to wake to, or press the
(To set Presets, see Setting and Using FM Presets on page 10.)
Using the
Buttons to tune in a desired wake to station.
or
or
8
iBT230
) to reset alarm.