Miller Electric Bobcat 225G Owner's Manual page 21

Miller electric owner's mnaual welding generator bobcat 225g
Table of Contents

Advertisement

C. Engine
Trouble
Engine will not crank.
Engine will not start.
Engine starts but stops when Engine
Control switch returns to Run position.
Engine stopped during normal opera-
tion.
Battery Discharges between uses.
Engine idles but does not come up to
weld speed.
Unstable or sluggish engine speeds.
Engine does not return to idle speed.
Check fuse F6, and replace if open (see Section 6-6).
Check battery voltage.
Check battery connections and tighten if necessary.
Check plug PLG4 and plug PLG8 connections.
Have Factory Authorized Service Agent check Engine Control switch S2.
Check fuel level.
Check battery voltage.
Check battery connections and tighten if necessary.
Check oil level. Check low oil pressure shutdown switch (see Section 3-4).
Have Factory Authorized Service Agent check fuel shutoff solenoid FS1.
Check oil level. Check low oil pressure shutdown switch (see parts list for location).
Check and refill crankcase with proper viscosity oil for operating temperature, if necessary.
Check fuel level.
Check oil level. Check low oil pressure shutdown switch (see Section 3-4).
Periodically recharge battery (approximately every 3 months).
Replace battery.
Check voltage regulator and connections according to engine manual.
Have Factory Authorized Service Agent check fuel shutoff solenoid FS1.
Clean battery, terminals, and posts with baking soda and water solution; rinse with clear water.
Periodically recharge battery (approximately every 3 months).
Replace battery.
Check voltage regulator and connections according to engine manual.
Have Factory Authorized Service Agent check auto idle module PC1, and current transformer CT1.
Readjust throttle linkage if necessary. Check throttle solenoid TS1 for smooth operation.
Tune-up engine according to engine manual.
Remove weld and auxiliary power loads.
Check throttle linkage for smooth, non-binding operation.
Have Factory Authorized Service Agent check idle module PC1, current transformer CT1, Engine Con-
trol switch S2, and throttle solenoid TS1.
Remedy
OM-175 104 Page 19

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bobcat 225g plus

Table of Contents