Casio MZ-X300 User Manual page 57

Configuring Digital Keyboard Settings
■ CONTROLLER Screen
Use this to configure pedal and pitch bend wheel settings.
Item
Knob1-2 Edit
Target
Min Value
Max Value
Upper1 Enable
Upper2 Enable
Lower1 Enable
Lower2 Enable
Auto Resolution
(Knobs 1, 2 only)
Modulation Edit
Pedal 1-2 Edit
Pedal 2 Type
Pedal 1 Mode
Pedal 2 Mode
Bend Range
EN-56
This is a group editable parameters for bq knobs (K1, K2).
Selects the parameters to be controlled by a controller. For example, the "CC67:Soft"
setting specifies a soft pedal effect.
• Two targets can be specified for a single controller.
Controller minimum output value setting.
Controller maximum output value setting.
Turning on this setting applies output MIDI messages to the Upper1 tone.
Turning on this setting applies output MIDI messages to the Upper2 tone.
Turning on this setting applies output MIDI messages to the Lower1 tone.
Turning on this setting applies output MIDI messages to the Lower2 tone.
Turning on this setting causes the amount of change applied when a knob is rotated
to be in accordance with the "Target", "Min Value", and "Max Value" settings.
When this setting is off, each click of a knob changes the applicable setting by one.
This is a group of es MODULATION wheel editable parameters. Details of the
editable parameters are the same as "Knob1 Edit", above.
Group of editable parameters for pedals connected to the PEDAL1, PEDAL2
terminals. Details of the editable parameters are the same as "Knob1 Edit", above.
Specifies whether the pedal connected to the PEDAL2 jack is to be used as a foot
switch or an expression pedal. Do not change this setting while the pedal is
depressed.
Selects the operation performed when the pedal is pressed.
Momentary: On while the pedal is depressed, off while the pedal is released.
Toggle: On after the pedal is pressed and remains on even if the pedal is released.
Off when the pedal is pressed again.
Specifies (in semitone units) how much the pitch of the keyboard performance parts
(Port A parts 1 through 5) changes when the pitch bend wheel is rotated all the way
upwards or downwards.
Description Setting
See the
separate
"Tutorial"
manual.
0 to 127
0 to 127
Off, On
Off, On
Off, On
Off, On
Off, On
Foot Switch,
Exp. Pedal
Momentary,
Toggle
00 to 24