Section 13 − Stick Welding (Smaw) Guidelines - Miller Electric 145 DXR, 145 Owner's Manual

SECTION 13 − STICK WELDING (SMAW) GUIDELINES
13-1. Stick Welding Procedure
2
1
Tools Needed:
5
4
7
3
6
Weld current starts when elec-
trode touches workpiece.
Weld current can damage elec-
tronic parts in vehicles. Discon-
nect both battery cables before
welding on a vehicle. Place work
clamp as close to the weld as
possible.
1 Workpiece
Make sure workpiece is clean be-
fore welding.
2 Work Clamp
3 Electrode
A small diameter electrode requires
less current than a large one. Fol-
low electrode manufacturer's
instructions when setting weld am-
perage (see Section 13-2).
4 Insulated Electrode Holder
5 Electrode Holder Position
6 Arc Length
Arc length is the distance from the
electrode to the workpiece. A short
arc with correct amperage will give
a sharp, crackling sound.
7 Slag
Use a chipping hammer and wire
brush to remove slag. Remove slag
and check weld bead before mak-
ing another weld pass.
stick 2007−04 − ST-151 593
OM-4417 Page 41