Checking/Adding Fuel; Fuel Filter; Check / Change Air Filter; Oil & Filter Change - Ferris IS1500ZKAV1944 Operator's Manual

CHECKING / ADDING FUEL
To add fuel:
1. Remove the fuel cap (see A, Figure 2).
2. Fill the tank to the bottom of the filler neck. This will
allow for fuel expansion.
NOTE: Do not overfill. Refer to your engine manual for
specific fuel recommendations.
3. Install and hand tighten the fuel cap.

FUEL FILTER

The fuel filter is located in the fuel line between fuel shut
off valve and carburetor, near the fuel pump. If filter is
dirty or clogged, replace as follows:
1. Disconnect the negative battery cable.
2. Place a container below the filter to catch spilled fuel.
3. Using a pliers, open and slide hose clamps from fuel
filter.
4. Remove hoses from filter.
5. Install new filter in proper flow direction in fuel line.
6. Secure with hose clamps.
7. Reconnect the negative battery cable when finished.
OIL & FILTER CHANGE
1. Warm engine by running for a few minutes. (Refer to
the engine operator's manual for oil & filter replace-
ment instructions.)
2. Remove the oil drain hose (A, Figure 11) from the
cable clamp (C) on the frame and route the hose
towards the rear of the machine as shown in Figure
11.
3. Place a small pan under the oil drain hose to catch
the oil.
4. Using the appropriate tools, remove the cap (B,
Figure 7) from the oil drain hose (A) and drain the
engine oil.
5. After draining, replace the cap and wipe up any
spilled oil.
6. Reintall the oil drain hose into the cable clamp to
retain the hose during normal operation.
7. Place an absorbent shop cloth under the engine oil
filter.
8. Remove the engine oil filter and replace with a new
one.
9. Remove the shop cloth and wipe up any spilled oil.
ENGINE MAINTENANCE
Refer to engine owners manual for all engine mainte-
nance procedures and recommendations
WARNING
Gasoline is highly flammable and must be
handled with care. Never fill the tank when the
engine is still hot from recent operation. Do not
allow open flame, smoking or matches in the area.
Avoid over-filling and wipe up any spills.
Do not remove fuel filter when engine is hot, as
spilled gasoline may ignite. DO NOT spread hose
clamps further than necessary. Ensure clamps
grip hoses firmly over filter after installation.
Do not use gasoline containing METHANOL,
gasohol containing more than 10% ethanol,
gasoline additives, premium gasoline, or white
gas because engine/fuel system damage
could result.
A
B
Figure 11. Engine Oil Drain
A. Oil Drain Hose
B. Cap
C. Cable Clamp
17
Regular Maintenance
C