Fisher & Paykel CleanSmart WL8060P Installation Instructions & User Manual page 37

Out of balance recovery routine
When your washer is spinning it can sense if the wash load is out of balance. If an out
of balance load is detected, the washer will stop and re-try spinning one more time. If it
still senses an unbalanced load there are two options the washer can take.
Automatic recovery OFF (default setting)
Your washer will stop, beep, and show
screen. You must redistribute the load more evenly yourself and touch
cycle. Use this option if you wish to conserve water.
Automatic recovery ON
Your washer will try to automatically correct the out of balance load. It will fill with
water and agitate to redistribute the load before trying to spin up again.
To change the out of balance (OOB) recovery routine:
Enter Option Adjustment mode (refer to page 32).
1
Select the 'Delicate' cycle.
2
Touch the 'More'
3
Wash Temp
Changing the OOB routine
End of cycle beeps
The beeps signalling the end of the cycle can be increased or decreased. The default
setting is 5 beeps.
To modify the number of beeps sounding at the end of the cycle:
Enter Option Adjustment mode (refer to page 32).
1
Select the 'Sheets' cycle.
2
Touch the 'More'
3
for no beeps to sound at the end of the cycle.
Wash Temp
Modifying the number of beeps to signal the end of the cycle
CHANGING PRE-SET OPTIONS
button to turn 'Automatic Recovery'
OOB Recovery
EOC Beeps
Factory Reset
or 'Less' button to increase or decrease the number of beeps, or
OOB Recovery
EOC Beeps
Factory Reset
in three phases on the display
or .
to resume the
35