Fisher & Paykel CleanSmart WL8060P Installation Instructions & User Manual page 31

Spin Speed
Your CleanSmart™ washer offers three spin speeds:
1100 rpm, 700 rpm and 300 rpm, plus an additional
'No Spin' option. Simply increase or decrease your
spin speed by touching the 'Spin Speed' button.
When you have selected 'No Spin', the cycle will end
after the rinse allowing you to remove drip dry items
before you spin the remaining items. Once drip dry
items have been removed, touch 'Power'
the 'Spin' cycle (change the spin speed if necessary,
eg select '300' for delicate or creasable items) and
touch .
Wash Boost
If you have stains in your wash load that you need
to treat or wish to perform a double wash, select
'Stain Treatment' or 'Dual Wash' from the 'Wash
Boost' options. Refer to the 'Wash Boost' section for
detailed information on these options.
Options
Soak
The 'Soak' option provides a two hour soak during
the middle of the wash phase of the cycle. The
washer will then complete the rest of the cycle.
During 'Soak', the washer will agitate for a few
seconds every minute. To perform a soak during a
cycle, simply select 'Soak' from the 'Options' menu.
To exit 'Soak' early, touch
select 'Rinse'. Change the 'Spin Speed' if necessary
(eg select 'Slow' if washing handwash only, delicate,
or creasable items) and touch
Note: if the soak option is selected on a 'Quick'
cycle, the soak time will be one hour only.
IMPORTANT!
Ensure items are colourfast before using soak.
● ●
DO NOT use your washer to soak items in bleach or sanitiser and if you've soaked
● ●
items in a bucket, do not tip the contents of the bucket into your washer. The
chemicals in these products are very corrosive to metal surfaces and can damage your
washer. Rinse and wring items out thoroughly before placing them in your washer.
WASH OPTIONS
, select
and turn the dial to
.
Selecting the 'No Spin' option
Selecting the 'Wash Boost' options
Selecting the 'Soak' option
29