Are the volume or expression settings too low?
[UTILITY] [Settings] [Sound] Tone Generator "Volume"
[EDIT] PART [COMMON] [General] "Volume"
[EDIT] Part selection ELEMENT/OPERATOR [COMMON] [Part Settings] [General] "Volume"
[EDIT] Part selection ELEMENT/OPERATOR [COMMON] [Part Settings] [General] "Dry Level"
• In case of Normal Part (AWM2) and Drum Part
[EDIT] Part selection Element/Key selection [Amplitude] [Level/Pan] "Level"
• In case of Normal Part (FM-X)
[EDIT] Part selection Operator selection [Level] "Level"
Are the parameter settings such as Element Switch, Note Limit, Velocity Limit, and Velocity Offset appropriate?
• In case of Normal Part (AWM2) and Drum Part
[EDIT] Part selection ELEMENT/OPERATOR [COMMON] [Part Settings] [General]
[EDIT] Part selection Element/Key selection [Osc/Tune]
• In case of Normal Part (FM-X)
[EDIT] Part selection ELEMENT/OPERATOR [COMMON] [Part Settings] [General]
Is the Mute switch for each Element/Operator of Part turned on?
[EDIT] Part selection Mute Switch of each Element/Operator
In case of Normal Part (FM-X), is the Carrier Level is set to "0"?
[EDIT] Part selection Operator selection [Level] "Level"
Is the output parameter of each Part turned off?
[EDIT] Part selection ELEMENT/OPERATOR [COMMON] [Part Settings] [General] "Part Output"
No sound from the A/D INPUT jack.
Is the switch of the microphone turned on?
Check the microphone type. Make sure to use a dynamic microphone.
Is the cable between the microphone or audio equipment and this instrument properly connected?
Is the A/D INPUT [GAIN] knob turned to the minimum?
Is the A/D INPUT [ON/OFF] button turned on?
Check whether or not the connection status of the A/D INPUT [L/MONO]/[R] matches the "Mono/Stereo" parameter.
[EDIT] PART [COMMON] [Audio In] [Mixing] A/D In "Input Mode"
Check whether or not the "Mic/Line" parameter is set to the appropriate value.
When the output level of the connected equipment (such as a microphone) is low, set this parameter to "Mic." When the
output level of the connected equipment (such as a synthesizer keyboard, CD player) is high, set this parameter to "Line."
[UTILITY] [Settings] [Audio I/O] "A/D Input"
Are the volume settings of the A/D Input Part too low?
[EDIT] PART [COMMON] [Audio In] [Mixing] A/D In "Volume"
Are the effect settings appropriate?
[EDIT] PART [COMMON] [Audio In] [Routing]
Is the output setting of the A/D Input Part set appropriately?
[UTILITY] [Settings] [Audio I/O] Output
Check whether or not the Vocoder Effect is selected.
When Vocoder is selected as the Insertion Effect for the current Part, the audio signal input from the A/D INPUT [L/MONO]/[R]
jacks may not produce any sound depending on the parameter settings.
[EDIT] Part selection ELEMENT/OPERATOR [COMMON] [Effect] [Routing]
Troubleshooting
59
MONTAGE Owner's Manual