Re-Assigning Device Keys - Universal Electronics Potenza ST User Manual

Nebula Potenza ST.fm Page 23 Monday, October 15, 2007 4:55 PM
4. Press and hold SETUP until the STB key blinks
twice.

RE-ASSIGNING DEVICE KEYS

The Potenza ST Universal Remote Control can be set up
to control a second device of an already-assigned type.
For example, to have the unit control a TV, a set-top box,
and two audio devices (for example, two audio
receivers), re-assign the unused VCR key to operate the
second audio device as follows:
NOTE: VCR is preset at the factory to control an RCA
VCR. Performing the steps below will over-
write those settings.
On the remote control, press VCR once; it will
1.
blink once. Then press and hold SETUP until
the VCR key blinks twice.
2. Enter 9 9 2. The VCR key will blink twice.
3. Press AUD once, then press VCR once. The VCR
key will blink twice.
The VCR key is now ready to be programmed for your
second audio device. See "Programming Device
Control" on page 9. To re-assign other device keys,
repeat these and substitute the key sequence using the
following chart:
NOTE: Only one device can be assigned to an unused
device key at a time.
To Re-Assign Perform Key Sequence
VCR as 2nd VCR SETUP 9 9 2 AUD VCR
AUD key
VCR as 2nd VCR SETUP 9 9 2 TV VCR
TV key
VCR as 2nd VCR SETUP 9 9 2 STB VCR
STB key
VCR SETUP 9 9 2 VCR VCR
VCR back to
VCR
www.urcsupport.com
23