Ice Bin; Quick Ice; Dispenser Controls; Ice Maker - Haier HRF24E3APS Installation And User Manual

Press LIGHT/FILTER for 3 seconds to reset the water filter status
after replacing the water filter.
ALARM/LOCK CONTROL
Switching the warning signal off/ switching panel lock on/off
Alarm function
•
The door alarm sounds if one of the doors is open for more than
one minute, or the temperature inside the refrigerator is too
high.
•
The alarm rings with 1 minute intervals and the "alarm" will blink
on the display.
•
To switch off the warning signal, close the door or press ALARM/
LOCK.
Lock function
•
Press ALARM/LOCK for longer than 3 seconds to activate the
lock which keeps the control settings from being unintentionally
changed. The Lock icon will appear on the display.
•
To release the lock function, press ALARM/LOCK for longer than
3 seconds. The Lock icon will disappear from the display.
QUICK ICE CONTROL

Quick Ice

The Quick Ice icon will appear in the display when the Quick Ice
function is on.

DISPENSER CONTROLS

Dispense Water
Dispense Cubed Ice
Dispense Crushed Ice

ICE MAKER

IMPORTANT:
•
Dispense water to flush air from the water system before
turning on the ice maker.
•
Do not store anything on top of the ice maker or in the ice
storage bin.
Turning the Ice Maker On/Off
The refrigerator comes with the ice maker turned on. The ice maker
has an automatic shutoff; when the ice storage bin is full, ice making
stops. To manually turn off the ice maker, remove the ice storage
10
bin and turn off the ice maker. See "Ice Bin" later in this section.
Ice Production Rate
•
Allow 24 hours to produce the first batch of ice. Allow 3 days
to completely fill the ice storage bin. Discard the first three
batches of ice produced.
•
The ice maker should produce about 8 ice cubes approx. 15
times per day.
•
To increase ice production, lower the freezer and refrigerator
temperature. See "Using the Controls." Wait 24 hours between
adjustments.
NOTE: The quality of your ice will be only as good as the quality
of the water supplied to your ice maker. Avoid connecting the ice
maker to a softened water supply. Water softener chemicals (such
as salt) can damage parts of the ice maker and lead to poor quality
ice. If a softened water supply cannot be avoided, make sure the
water softener is operating properly and is well maintained.

ICE BIN

To remove and replace the ice storage bin:
1. Press the release button and remove the ice storage bin.
2. The On/Off switch is located on the side of the ice maker.
Turn off the ice maker by pressing and holding the switch for
2 seconds.
3. Empty the ice storage bin.
4. Clean with lukewarm water. Thoroughly dry the bin and turn the
ice auger coil to prevent new ice cubes from sticking.
5. Turn on the ice maker by pressing and holding the switch for
2 seconds.
6. Insert the ice storage bin into the ice maker pushing the bin all
the way back onto the supports until it locks into position.
NOTE: If the ice bin cannot be pushed all the way back, rotate
the coil a quarter turn and reinsert the ice bin.