Buick Cascada 2016 Manual page 53

52 Seats and Restraints
To fold the rear seatbacks:
1. Remove the wind deflector if
installed.
2. Move the front seats forward or
remove the rear head
restraints. See Power Seat
Adjustment 0 48 or Lower
Anchors and Tethers for
Children (LATCH System) 0 77
for head restraint removal
instructions. Store the head
restraints in the cargo area.
3. Pull the release switch in the
trunk to fold the rear
seatback down.
4. Fold the seatback forward.
5. Repeat Steps 1 4 for the other
seatback, if necessary.
To raise the seatback:
Warning
A safety belt that is improperly
routed, not properly attached,
or twisted will not provide the
protection needed in a crash. The
person wearing the belt could be
seriously injured. After raising the
rear seatback, always check to be
sure that the safety belts are
properly routed and attached, and
are not twisted.
1. Lift the seatback up and push it
rearward until it latches into
place. Keep the safety belts
clear of the seatback and
untwisted.
Warning
If the seatback is not locked, it
could move forward in a sudden
stop or crash. That could cause
injury to the person sitting there.
Always pull forward on the top of
the seatback at the area of the
latch to be sure it is locked.
2. Push and pull on the seatback
to make sure it is locked into
position.
3. Reinstall the head restraints,
if necessary. See Lower
Anchors and Tethers for
Children (LATCH System) 0 77
for head restraint reinstallation
instructions.
4. Repeat Steps 1 3 for the other
seatback, if necessary
Keep the seat in the upright locked
position when not in use.