Buick Cascada 2016 Manual page 25

24 Keys, Doors, and Windows
Some vehicles may have a feature
that also allows the convertible top
to open. See Power Windows 0 34.
The turn signal indicators may flash
to indicate unlocking. See Vehicle
Personalization 0 113.
Pressing will disarm the alarm
system. See Vehicle Alarm
System 0 31.
: Press to lock all doors. Press
and hold the lock button to close all
windows.
The turn signal indicators may flash
and/or the horn may sound to
indicate locking.
If the driver door is open when
pressed, all doors lock and the
driver door will immediately unlock,
if enabled through vehicle
personalization. See Vehicle
Personalization 0 113.
If the passenger door is open when
is pressed, all doors lock.
Pressing may also arm the alarm
system. See Vehicle Alarm
System 0 31.
: Press and hold to release the
trunk.
: Press and release one time to
initiate vehicle locator. The exterior
lamps flash and the horn chirps
three times.
Press and hold
three seconds to sound the panic
alarm. The horn sounds and the
turn signals flash for 30 seconds,
or until is pressed again or the
vehicle is started.
: If equipped, press to operate
the remote start feature. See
Remote Vehicle Start 0 26.
The buttons on the transmitter are
is
disabled when there is a key in the
ignition.
Programming Transmitters to
the Vehicle
Only RKE transmitters programmed
to the vehicle will work. If a
transmitter is lost or stolen, a
replacement can be purchased and
programmed through your dealer.
The vehicle can be reprogrammed
so that lost or stolen transmitters no
longer work. Any remaining
transmitters will need to be
reprogrammed. Each vehicle can
have up to eight transmitters
matched to it.
Programming with a Recognized
Transmitter
for at least
To program a new key:
1. Insert the original, already
2. Turn the key to LOCK/OFF,
3. Insert the new key to be
4. Repeat Steps 1 3 if additional
If a key is lost or damaged, see your
dealer to have a new key made.
programmed key in the ignition
and turn the key to the ON/
RUN position.
and remove the key.
programmed and turn it to the
ON/RUN position within
five seconds.
The security light will turn off
once the key has been
programmed.
keys are to be programmed.