Yaesu FT DX 3000 Operating Manual page 26

f p
ront anel
[ BAND ] Keys
These keys allow one-touch selection of the desired
mateur and .
The keys may also be used for direct entry of a de-
sired operating fre uency during
[ RX CLAR ] Switch
ressing this utton acti ates the
will allow you to temporarily adjust the receive fre-
uency up to .
B no . ress this utton once more to return the
recei er to the original fre uency the larifier offset
ill e remem ered in case you ant to use it again.
larifier offset press the [ CLEAR
o cancel the
button.
ressing the [ VFO-B/CLAR button followed by
this switch will change the tuning rate of the [ CLAR/
VFO-B no
hen this function is acti ated
the TFT display.
Page 24
c
ontrols
.
operation.
larifier. his
ith the [ CLAR/VFO-
to step.
appears in
& s
witches
[ MODE ] Switch
This button selects the operating mode. The selec-
tions a aila le are
LSB à à
à
epeated presses of this utton steps through the
available selections.
ressing and holding this utton
alternate mode.
or e ample In the LSB or USB modes a long
press of this utton toggles et een
mode.
[ MHz/µT ] Switch
ressing this utton allo s you to tune the
uency do n or up in
[ CLAR/VFO-B knob.
ressing and holding this s itch for one second al-
lo s you to adjust the center fre uency of the
uning filter pass and using the [ CLAR/VFO-B
no hen the optional
nected. hile acti ated the
glo s red. ress and hold in the [ MHz/µT switch
for one second to toggle the
off.
F T 30 00 O
DX
à
à LSB à
à
ill toggle to the
and
fre-
increments using the
uning it is con-
inside this utton
uning function on
M
peraTing anual